Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving all of California

Roll-Up Door Repair in California

Sheet roll-up doors for storage units, sheds and warehouses repaired. Typical cost $150-$600.

Our roll-up door repair service in California comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Sheet roll-up doors for storage units, sheds and warehouses repaired.

Signs you need roll-up door repair

  • The door is hard to lift or won't stay up
  • A dented or creased curtain
  • The latch won't lock
  • The door comes out of its guides

What usually causes it

  • Loss of spring tension
  • Impact damage
  • Worn latches and stops

Before the technician arrives

  • Check whether the stops at the top of the guides are in place.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our roll-up door repair process

  1. Inspect the curtain, guides and drum
  2. Adjust or replace the springs
  3. Repair the curtain or replace the door
  4. Replace latches and stops
  5. Test it

Roll-Up Door Repair cost in California

$150-$600Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size, gauge and cycle rating
  • Operator type and controls
  • Parts availability for your model
  • Lift equipment and after-hours access

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Roll-Up Door Repair in California

Coastal moisture and salt in California rust cables, hinges and roller bearings, while inland dust packs into the tracks.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

We cover 841 cities and towns across California. Find roll-up door repair in your city:

Roll-Up Door Repair: frequently asked questions

How much does roll-up door repair cost in California?

Roll-Up Door Repair typically costs $150-$600 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do roll-up door repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is roll-up door repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where California or your city requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my commercial door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the commercial door is near the end of its life, replace it. Commercial doors are rated by cycles. If the door has reached its rated cycle life, has several damaged sections, or parts are no longer made, replacing it is often cheaper over the next few years. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in California

Hörmann Smart Garage Door Opener Setup

Wi-Fi openers and smart hubs set up so you can open, close and monitor from your phone.

Typical $100-$900

Ryobi Remote & Keypad Programming

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $50-$150

Haas Door Weather Seal Replacement

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $100-$300

Martin Door Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Hörmann Garage Door Track Repair

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $150-$400

Moore-O-Matic Opener Circuit Board Replacement

Moore-O-Matic openers are no longer made. We can often keep one running with available parts, or recommend a modern replacement.

Typical $175-$400

LiftMaster Commercial Door Operator Repair

LiftMaster also makes commercial trolley, jackshaft and hoist operators for sectional and rolling doors.

Typical $300-$1,200

Loading Dock Door Repair

Dock doors, seals and bumpers repaired to keep shipping moving.

Typical $300-$1,200

Midland Garage Door Extension Spring Replacement

Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Typical $150-$350

Genie Opener Circuit Board Replacement

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $175-$400

Haas Door Garage Door Repair

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $150-$450

Richards-Wilcox Extension Spring Replacement

Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Typical $150-$350

Garage door stuck, noisy or broken?

Talk to a garage door technician in California now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote